This was a straight forward request to clean and re-seal a Victorian Minton tiled floor in Coventry. The tiles were in good condition but there were a few stubborn stains that needed dealing with.
Cleaning Victorian Tiles
I used a concentrated dilution of Tile Doctor Pro-Clean to clean and strip the old sealer from the floor. It was first left to soak into the tiles for around 15 minutes before being scrubbed into the Victorian tile and grout using a slow speed rotary machine fitted with a scrubbing pad. The dirty solution was removed and the process repeated and grout lines scrubbed until I was happy the tiles were clean; this was then followed with a thorough rinse with water and a wet vacuum was used to remove the fluids and get the tile and grout as dry as possible. This process took most of the day so once the floor was clean I left for the day leaving it to dry overnight.
Sealing Victorian floor tiles
I came back the next day and after confirming the tiles had dried I began sealing them using six coats of Tile Doctor Seal and Go sealer which will provide stain protection as well as adding a nice shine to the floor. The interesting thing about Seal and Go is that’s it’s a water based sealer so you don’t get a smell as it dries.
Victorian tiled floor cleaned and sealed in Coventry
Details below of a bread and butter job recently completed in Coundon near Coventry to Clean, repair and seal Victorian floor tiles. I call it a bread butter job as this is something we do a lot off and have therefore become quite proficient including colour matched repairs to grout and tile replacement.
Cleaning Victorian Tiles
The tiles were quite dirty and in need of a deep clean so a 50/50 mix of Tile Doctor Pro-Clean and NanoTech UltraClean was diluted with water and left to soak into the tiles for around 15 minutes before being scrubbed into the Victorian tile and grout using a slow speed rotary machine fitted with a scrubbing pad. The dirty solution was removed and the process repeated and grout lines scrubbed until I was happy the tiles were clean; this was then followed with a thorough rinse with water and a wet vacuum was used to remove the fluids and get the tile and grout as dry as possible. We have a special fan to accelerate the drying process so this switched on and moved around the floor until it was dry.
Sealing Victorian floor tiles
Once the floor was dry we started to seal it using Tile Doctor High Shine sealer which provides stain protection as well as a very shiny finish, hopefully you can appreciate the difference in the photographs on this page.
Victorian tiled floor cleaned and sealed near Coventry
This Limestone Tiled Floor was installed in the hall and kitchen of a residence in Coventry. The floor had scratch damage in the middle of the kitchen and was dull from the previous use of the wrong cleaning products, the house had recently been sold and the new owners wanted the damage removed and Limestone sealed and polished so it looked new again.
Cleaning Limestone and Grout
The first task was to give the floor a general clean using a dilution Tile Doctor Pro-Clean with the focus on the ensuring the grout lines were given a good scrub to get them looking clean again. The dirty solution was then removed from the floor using a wet vacuum and rinsed with clean water.
Limestone like Marble and Granite is a very hard stone and needs to be cutback with burnishing pads to get it looking good again; the pads fit a rotary buffing machine and applied with a little water. Tile Doctor supplies a four pad Burnishing set for this purpose and you start off using a coarse pad to cut back the dirt from the floor and then move through the pads until you get to the last one which is very fine and polishes up the stone.
Sealing Limestone Floor Tiles
To protect the floor it was sealed with two coats of Tile Doctor Colour Grow which is designed to lift the natural colours in the stone and will protect the tile from stains in future.
In total the floor took eight hours to clean and re-polish, the scratch was gone and the floor now looks new again, just what the customer wanted.
These mixed milled slate floor tiles were installed in the Kitchen, Hall and toilet of a house in Broadwell, Warwickshire. The Slate was staining easily from drink spills and proving hard to clean; on top of that all the tiles were covered in a slight grout haze and had not been sealed or cleaned properly after installation. The customer needed the floor to be easy to clean and manage and was keen to bring out the rich colour and texture of the floor but keep a matt finish.
Cleaning black slate floor tiles
The first job was to give the floor a deep clean using Tile Doctor Pro-Clean which was worked into the pores of the Slate tile and grout using a slow speed rotary machine fitted with a scrubbing pad. I then used a wet vacuum to remove the resultant soiled solution and rinsed the floor down with water.
Removing Grout Haze from Slate
The next step was to tackle the grout haze which was evident across the tiles; for this we used Tile Doctor Grout Clean-Up which is an acidic product that you allow to dwell on the tile for a one to two minutes and then agitate with a scrubbing pad and then remove shortly afterwards with a wet vacuum washing the floor down quickly to ensure the acid is removed.
Further cleaning was required to some areas which had proven stubborn to clean earlier and for this we used Pro-Clean again mixed 50/50 with NanoTech UltraClean which adds tiny abrasive particles to make a more effective cleaning product; again this was scrubbed in and then once we were happy with the result the floor was washed down with clean water in order to neutralise it before sealing.
Sealing Slate floor tiles
I left the floor overnight to dry then came back next day and used a damp test meter to verify the floor was dry and ready for sealing. Once happy I proceed to apply four coats of Tile Doctor Colour Grow which matched their requirements in a sealer exactly as it provides a matt finish brings out the colour in the stone and offers great stain protection.
Slate tiled floor cleaned and sealed in Warwickshire